Engine Running and Dead in Reverse and on Stop but They Start It Again Park Position Ford 150
- Get link
 - X
 - Other Apps
 
Q: Car turns off. First it would turn off in reverse and when I would stop at a red lite or dull downward to make a turn.
Car turns off. Start it would plough off in contrary. So when I would stop at a cherry-red light or tedious down to make a plow. It turns back on similar normal. When I drive it in the freeway non stop it doesn't plow off. The throttle body was replaced. Two sensors almost the calculator were replaced. I took it to an electronic shop and they said they couldn't run into anything wrong with it. I finally took it to a transmission store and they said its not the transmission. Please assist me. I don't know what else tin it be. I'm planning on taking information technology back to my mechanic tomorrow morning. Its an old car only its reliable until now. It has over 221k miles, automated, one.8 engine.
Cheers in advance for hearing me out. Nehv
My car has 221500 miles.
                  My automobile has an automated transmission.
Recommended Services
                                      
Hi in that location. For the reverse stalling condition, check the Idle Air Control Valve and encounter if its plugged upward. If a IAC valve is plugged up, an engine volition stall out when going into gear and could cause issues when slowing downwards. For the steering and stalling outcome, check the power steering fluid and see if its low. If the fluid is total, then the pressure level control valve in the ability steering is not releasing causing the pump to load up making the engine stall. Try turning the vehicle with the engine running and at a stopped location.
If the engine stalls out, and then its the force per unit area control valve, but if it does not stall out, and so there could exist an issue with the transmission.
If you need further assistance with your engine stalling, then seek out a professional person, such equally one from Your Mechanic, to help you.
The statements expressed above are but for advisory purposes and should be independently verified. Delight encounter our terms of service for more details
Get an instant quote for your auto
Our certified mechanics come to y'all ・Backed past 12-month, 12,000-mile guarantee・Fair and transparent pricing
Experienced Mechanic?
Earn up to $70/hr
What others are asking
Advice on buying the first car
Unfortunately, I don't want to jinx yous, simply the offset machine people get is the first car they wreck. I would say go a nice, used Toyota (https://www.yourmechanic.com/cars/toyota). You pay less, your insurance will exist a lot cheaper. As time...
Water pump/water pump pulley is bad?
Hey in that location. When you move the fan, if you see the pulley moving up and down then yous have a water pump bearing that went out. Yous should also notice if there is a wobble of the cooling fan clutch...
My car is overheating - 2000 Toyota Celica
This may be caused by a faulty coolant fan relay. As yous may know the coolant fan switch (https://world wide web.yourmechanic.com/services/cooling-fan-relay-replacement) helps to maintain the proper coolant temperature by turning on and off at specific temperature thresholds. When this switch is non...
94 Taurus starter issue
Hello there: The clicking sound accompanied past white smoke is a mutual sign of a failed starter solenoid. The starter solenoid is located on the starter and has internal electrical contacts that transmit electricity to the starter. When this fails,...
Changed thermostat now have no heat 2000 Chevrolet Silverado 1500
Hullo - you are on the right rail, at that place is likely an air pocket in your heater, preventing the heater (https://world wide web.yourmechanic.com/question/my-heater-is-non-working-by-brandon-a) from working properly. To bleed the heater core as well as the engine cooling organization: fill engine with coolant,...
Is p0016 for sensor A or B on a 2010 2.4L ecotec 4cyl.
P0016 (https://www.yourmechanic.com/article/p0016-obd-two-trouble-lawmaking-camshaft-position-a-camshaft-position-correlation-bank-1-by-jay-safford) pertains to the intake camshaft (i.e., position "A"). If that code has fix, apart from a sensor fault, there are quite a few other potential causes of the lawmaking, including: incorrect camshaft timing due to the timing concatenation...
Related articles
How to Turn Off the Reverse Beep in a Prius
The The Toyota Prius is designed to shut off the engine when stopped as an energy-conserving measure. When the accelerator is depressed, it starts to back up, so you can get about your business organization on the route. When your Prius...
How Long Does a Superlative Dead Center (TDC) Sensor Concluding?
The The peak dead centre (TDC) sensor is the bespeak from which the firing social club is determined and the ignition organisation measurements are taken. The measurements are commonly defined as before top dead eye and after meridian dead center. The...
Browse other content
Source: https://www.yourmechanic.com/question/car-turns-off-first-it-would-turn-off-in-reverse-and-when-i-would-stop-at-a-red-light-or-slow-down-to-make-a-turn-i-ve-taken-my-by-nev-v
- Get link
 - X
 - Other Apps
 

Comments
Post a Comment